On Tue, Feb 17, 2015 at 9:19 PM, William Park <opengeometry@yahoo.ca> wrote:
Disk failed last September, and you're replacing it now? Boy, you got balls!
You are better off to use whatever utility you used in the first place. Manual typing would go something like man mdadm cat /proc/mdstat
understand above commands
mdadm -D -v /dev/md0
what does this command do/mean?
mdadm /dev/md0 --add /dev/sdx
(I understand I will need a different letter instead of the x) what does this command do/mean?
where /dev/sdx is the new disk. Here, the new device should be the "same" as the old. If the old was a partition (eg. /dev/sda1), then the new should be a partition. If the old was entire device (eg. /dev/sda), then the new should be entire device also. --
I am not asking the questions to be confrontational just have learned that typing in commands the results of which you do not know or the effect you do not know/understand can have large effects. (In the past I have too often totally borked my system and I really don't want to take two weeks from my life and spend all day trying to reestablish things.) Thanking you for your interest and assistance! Dee
William
Greetings
I have been running a raid 10 array for almost 3 years.
Last September on a reboot (forced by Firefox and kernel memory interaction problems) came up with one of the drives being listed as DOA. The raid array has continued to run on 3 drives although on reboots there is much complaining from whatever in the boot up process. I had the replacement drive sent to me and today I installed the drive.
I was under the assumption that the raid array would rebuild itself upon startup with a new drive (4th out of 4).
This did not happen.
I am running Debian Jessie (testing) and have the whole time in question. I can mount the array and it is visible. I'm looking at backing up the array (on blu-ray discs) but as I'm now to circa 45 GB of data and I was at about 22 GB when I last did a backup
is going to be a momentous event.
How do I ask mdadm to include this new drive into the array? (Without borking everything!! I have found lots of instructions on how to create but none in an hour of trying different search phrases on how to rebuild or how to cause the array to rebuild itself. I have only been able to find instructions for when the array is totally sick and I'm not there (yet -
On Tue, Feb 17, 2015 at 03:42:07PM -0600, o1bigtenor wrote: this -
- grin!) but I don't want to wait until another drive craps out to get things going.)
TIA
Dee
--- Talk Mailing List talk@gtalug.org http://gtalug.org/mailman/listinfo/talk
--- Talk Mailing List talk@gtalug.org http://gtalug.org/mailman/listinfo/talk